5 modelsFast injection molding machines with 200 mm/s injection speed that shorten the molding cycle by 25-50%, lower energy consumption and raise output.
DKM Victor Series — Fast Injection Molding Machines (200 mm/s)
The DKM Victor series are fast injection molding machines with an injection speed of 200 mm/s, designed to improve molding quality and efficiency. Fast injection is one of the main trends of the plastic injection molding sector. While providing precise molding, the Victor series shortens the molding cycle by 25-50% (depending on the mold and part characteristics), lowers energy consumption and significantly increases production capacity.
Series Comparison
| Feature | SV Series (Standard) | Victor Series (Fast) | DFS Series (High Speed) |
|---|---|---|---|
| Injection Speed | 0-100 mm/s | 100-200 mm/s | >300 mm/s |
| Cycle Time | Standard | Fast | Faster |
| Energy Consumption | Low | Low | Standard |
| Cost | Low | Medium-Low | High |
Why fast injection?
Standard machines (≤100 mm/s): Slow melt filling, early solidification in the mold corners, difficulty in holding pressure. Excessive pressure is needed to prevent sink marks → mold wear, an increase in part weight, a high defect rate.
Victor (200 mm/s): The filling time is shortened by 50% and the melt keeps its flowability. A seamless transition between injection and holding pressure, simultaneous cooling in the mold cavity. The stress stays balanced, cycle times get shorter and output rises.
Cost/energy advantage over high speed machines: Victor is far more economical than high speed machines.
Key Advantages
#### The Molding Cycle Is Shortened by 25-50%
- Filling time is reduced by ≥50% — high speed screw advance technology
- Holding pressure time is reduced by ~20% — a thick molten core layer provides better compensation
- Cooling is 50% shorter — the melt enters the cooling phase earlier
- Mold opening-closing is 100% faster — proportional valves and differential mold clamping technology
#### The Defect Rate Falls Significantly
- Surface sink marks disappear — thanks to a homogeneous melt and efficient holding pressure
- Flash formation is reduced — low holding pressure minimizes the risk
#### Energy Saving and High Quality
- 20%+ energy saving — a shortened cycle
- 5% additional saving — low holding pressure
- Higher output per unit of time — high quality production at low cost
Structural Performance
Power: Thanks to a strong power system, adaptation to a wide range of materials and processes, and a solution for complex production requirements.
Speed:
- Fast mold filling → low part stress, high output
- Standard proportional valves → fast and stable mold opening-closing
- High performance plasticizing → fast and homogeneous melting
Efficiency: With structural optimization and system upgrades, output per unit of time rises by 25-50%.
Energy Efficiency:
- Electric pre-plasticizing — simultaneous plasticizing, a 20-30% increase in energy efficiency
- Infrared heater bands — heat loss is minimized and heat radiation into the workshop is reduced
High injection speed is what distinguishes VICTOR. If you are looking for a more economical solution at the same tonnage, assess it side by side with the SV and DH series on the injection molding machine comparison page.